CHAPTER ONE / GENERAL INFORMATION
Manual organization / Notes, cautions and warnings / Torque specifications /
Engine operation / Fasteners / Lubricants / Gasket sealant / Galvanic corrosion
/ Protection from galvanic corrosion / Propellers
CHAPTER TWO / TOOLS AND TECHNIQUES
Safety first / Basic hand tools / Test equipment / Service hints / Special tips
/ Mechanic's techniques
CHAPTER THREE / TROUBLESHOOTING
Troubleshooting test equipment / Troubleshooting preparation / Starting
difficulty / Fuel system component testing / Starting system / Ignition system /
Warning systems / Oil injection system / Charging system / Power head / Cooling
system / Gearcase / Trim system / Electronic fuel injection
CHAPTER FOUR / ROUTINE MAINTENANCE, LUBRICATION AND TUNE-UP
Routine maintenance / Tune-up
CHAPTER FIVE / SYNCHRONIZATION AND ADJUSTMENT
Shift cables and linkage / Throttle cable and linkage / Pilot screw / Idle speed
/ Choke solenoid / Throttle position sensor (TPS) / Oil pump linkage adjustment
/ Ignition timing
CHAPTER SIX / FUEL SYSTEM
Carburetor / Intake manifold / Electronic fuel injection (EFI) system
CHAPTER SEVEN / ELECTRICAL AND IGNITION
Starting system / Charging system / Ignition system / Warning system / Battery
requirements
CHAPTER EIGHT / POWER HEAD
Flywheel removal and installation / Break-in procedure
CHAPTER NINE / GEARCASE
Gearcase operation / Gearcase removal and installation / Water pump / Gearcase
disassembly / Shim selection / Gear pattern inspection
CHAPTER TEN / JET DRIVES
Jet drive removal and installation
CHAPTER ELEVEN / MIDSECTION
Clamp brackets
CHAPTER TWELVE / POWER TRIM SYSTEM
Fluid filling / Air bleeding
CHAPTER THIRTEEN / OIL INJECTION SYSTEM
Oil flow switch removal, inspection and installation / Bleed air from the system
